FREE DELIVERY WITH ORDERS OVER $150

Mounting Kits

Wood Screws

Kit contains: Four solid brass screws. This kit is designed for hanging your sign on doors, fences and other wooden structures. This kit is ideal if you wish to hang your sign in the traditional way, with just the right, original, look. The solid brass screws will patinate and stay unchanged for an eternity, lending to the timeless beauty of your sign.

 

 

Brick Screws

Kit contains: Four solid brass screws, four washers, and four plugs. This mounting kit is designed for hanging your sign on stone, brick or concrete walls and structures. One washer is placed under each screw head to protect the porcelain enamel surface. Just like Option #1, this kit is ideal if you wish to hang your sign in the traditional way, with just the right, original, look. The solid brass screws will patinate and stay unchanged for an eternity, lending to the timeless beauty of your sign.

 

 

Adhesive Tape

3M VHB (Very High Bonding) Tape designed for mounting your flat sign on a flat even surface. 3M VHB Tapes are high-strength bonding tapes and a proven alternative to screws, rivets, welds and other mechanical fasteners. This option is ideal if you are looking for a clean, easy, and elegant solution without the need for drilling and screws. For safely fastening your sign onto your mailbox, vehicle, or vessel (or any surface which must remain intact) this option is recommended, as you can remove your sign again without leaving mounting holes. While this tape is very durable and expected to hold your sign safely in place for at least two decades, you should expect to replace it at some point in the future.

 

Mounting Instructions
To avoid damaging your sign use only the included Ramsign-certified mounting materials. Do not tighten the screws as the pressure can damage the enamel. The screw head should not even touch the enamel. Faulty mounting may cause irreparable damage that is not covered by any warranties.